Using IPCS in batch or line mode

z/OS MVS IPCS User's Guide contains an example of how to invoke IPCS in a batch job or in line mode using subcommands. To access the JES2 information in the dump, you must enter the following subcommand:

VERBEXIT JES2VX 'jesname'

This subcommand formats and prints the following information from the dump:

HCCT
$HCT
Current $PCE
Save areas ($PSVs) related to the current $PCE
Routine name associated with each $PSV
JES2 module and offset of the caller, from which each routine was called
$DCT related to the current $PCE
$JQE related to the $DCT
$JOEs related to the $PCE.

The optional parameter, JESNAME, allows the installation to specify the name of a particular JES2 address space to analyze. If JESNAME is not coded, the formatter analyzes the address space with the name JES2.