Parameter Description for FSS(accccccc)

PROC=accccccc

Specifies the 1- to 8-character name of the procedure in the PROCxx concatenation used for the started tasks that contains the JCL required to start the functional subsystem.

This parameter defaults to the value specified as the FSS subscript name (accccccc).

Modification: $T FSS operator command (if the address space is inactive).

AUTOSTOP=Yes|No

Specifies whether (Yes) or not (No) the FSS address space is to be stopped (shut down) if all the devices attached to the FSS are drained.

Note: If an error occurs while the FSS address space is stopping, you may have to issue an MVS™ CANCEL to end the address space before starting another printer to this FSS.

Modification: $T FSS operator command.

HASPFSSM=accccccc|HASPFSSM

Specifies the 1- to 8-character name of the load module to be loaded into the functional subsystem address space. This load module contains the various JES2-supplied FSI service routines.

If your installation uses the default libraries and module names for the JES2 component, as distributed by IBM, omit this parameter or code HASPFSSM=HASPFSSM. If your installation manages the JES2 components in another way, ensure that the correct level of the HASPFSSM module is available to an FSS address space when an FSS is started.

For example, if your installation manages multiple versions of JES2 in libraries that are specified as a STEPLIB in JES2 cataloged JCL procedures, a similar library structure is required for HASPFSSM. The appropriate version of HASPFSSM must be available to the address space of the FSS through a //STEPLIB DD statement in the cataloged JCL procedure for the FSS.

If the load module specified by HASPFSSM= is not found during the start of the FSS address space, or if it is found but its version and structure do not match the rest of the JES2 component, JES2 returns an error code to the FSS that is attempting to connect to JES2.

Modification: $T FSS operator command (if the address space is inactive).