|
- NUM=nnnnnnnn|100
- Specifies the default estimated punched card output (0-99999999)
for a job after which the $HASP375 message is written to inform the
operator that the estimated punch card output has been exceeded. This
value is used if you do not specify a value for the estimated punch
card count in the accounting field of your JOB statement or by using
the CARDS= keyword on the /*JOBPARM control statement, or by using
the CARDS= keyword on the JOB statement.
Modification: $T ESTPUN operator command or
cold start. If you modify this parameter value and then restart JES2
with a warm or hot start, the parameter value in effect before termination
will be used.
- INT=nnnnnnnn|2000
- Specifies the interval (1-99999999), in cards, at which message
$HASP375 is written to inform the operator that a job has exceeded
its estimated output. The message is initially issued when the output
estimate (NUM= value) for the job is exceeded.
Modification: $T ESTPUN operator command or
cold start. If you modify this parameter value and then restart JES2
with a warm or hot start, the parameter value in effect before termination
will be used.
- OPT=0|1|2
- Specifies the action JES2 takes when a job exceeds the estimated
number of cards. The following are the options and subsequent action:
- 0
- job is allowed to continue execution
- 1
- job is canceled without a dump
- 2
- job is canceled with a dump (if a dump statement was coded for
this job step)
Modification: $T
ESTPUN operator command.
|