$HASP196

devname

Explanation

>>-+-ERROR-+--ON--devname--WHILE INVOKING -text----------------><
   '-ABEND-'                                      

 JES2 detected an error or abend during a installation
exit or a scheduler JCL facility (SJF) service while printing or punching
a job's output.
 In the message text:  devname
The name of the printer or punch.

 text is one of the following:
 EXIT 1
JES2 encountered a problem while Exit 1 was in control.
EXIT 15
JES2 encountered a problem while Exit 15 was in control.
SWBTUREQ RETRIEVE
JES2 was processing a scheduler JCL facility SWBTUREQ RETRIEVE request.
SWBTUREQ SPLICE
JES2 was processing a scheduler JCL facility SWBTUREQ SPLICE request.
SJFREQ SWBTUMERGE
JES2 was processing a scheduler JCL facility SJFREQ SWBTUMERGE request.
SWBTUREQ RETRIEVE RC=nn,REASON=nnnn
JES2 was processing a scheduler JCL facility SWBTUREQ RETRIEVE request.
This form of the text includes a return code (RC) and a reason code.
SWBTUREQ SPLICE   RC=nn,REASON=nnnn
JES2 was processing a scheduler JCL facility SWBTUREQ
SPLICE request. This form of the text includes a return code (RC)
and a reason code.
SJFREQ SWBTUMERGE RC=nn,REASON=nnnn
JES2 was processing a scheduler JCL facility SJFREQ SWBTUMERGE request.
This form of the text includes a return code (RC) and a reason code.

System action
 When text is SWBTUREQ RETRIEVE with
an ERROR, JES2 stops processing the output and then purges the output.
When text is SWBTUREQ SPLICE, JES2 does
not insert the SWBTU into the SMF type 6 record, and processing continues.
For all other cases, JES2 puts the output into hold (HOLD=SYS) and
continues processing.

Operator response
 See the operator response for message $HASP197.

System programmer response
 None.

Module
 HASPPRPU
 Routing
Code: 7,10
 Descriptor Code: 4