$HASP125

devname

Explanation

>>-devname--SKIPPING FOR JOB CARD -+----------+----------------->
                                   '-orgjobid-'   

>--+------------+----------------------------------------------><
   '-FROM--text-'   

 The JES2 input service processor is scanning
the input stream for a JOB card. This message may be accompanied by
diagnostic messages indicating that errors have been encountered in
the reading of jobs. In the message, text is one
of the following: ijobid ijobname
userid AT nodename

 In the message:  devname
The name of the device on which the input was entering the system.
If the device name is INTRDR, this message also displays ijobid and ijobname.
orgjobid
The job identifier or VM/RSCS spool file identifier from which
this job originated. JES2 only displays this information if the job
enters the system from the network.
ijobid
The job identifier of the job that is submitting this job. This
information is displayed only if the device name is INTRDR.
ijobname
The name of the job that is submitting this job. This information
is displayed only if the device name is INTRDR.
userid
The TSO/E userid that originated this job. JES2 only displays
this information if the job enters the system from the network. If
JES2 cannot identify the userid that originated this job, this field
will display *UNKNOWN.
nodename
The name of the node from which this job originated. JES2 only
displays this information if the job enters the system from the network.
If JES2 cannot identify the node from which this job originated, this
field will display *UNKNOWN.

System action
 The input service processor continues to read
the input stream until a JOB card is encountered or until an end-of-data
condition is recognized.

Operator response
 If you entered a command to delete a job
currently on the device, perform the appropriate action consistent
with the reason for deletion. If skipping is caused by the deletion
of a job because of an error encountered, inform the programmer of
the error. Otherwise, check the input stream to make sure that the
cards are in correct order and resubmit the corrected jobs after canceling
any that were incorrectly entered.

Programmer response
 Correct the JCL in accordance with the
accompanying error messages.

Module
 HASPRDR, HASCINJR, HASCNJJR
 Routing
Code: 7
 Descriptor Code: 4