$HASP880

dev

Explanation

>>-+- LINElna UNIT= --+- dev -+-+-- keyword=value,... ---------><
   |                  '- SNA -' |                        
   '- ,STATUS=  -- status, -----'                        

 JES2 issues this message in response to a:
 $D or $T command that specified the LINE(nnnn) initialization
statement.
$DU command that either implicitly or explicitly specified the
LINE(nnnn) initialization statement.
$S, $P, or $E command that specified LINE(nnnn) devices.

 If this message is issued in response to a $DU, $S, $P,
or $E command, only UNIT= and STATUS= may be displayed. Otherwise,
the message displays all the keywords on the LINE(nnnn) statement
that are related to this type of line (SNA or BSC, as defined by the
UNIT= parameter) and their current values. The description of the
LINE(nnnn) statement in z/OS JES2 Initialization and Tuning Reference  explains most of the keywords. Further information
can be found under $HASP603.
 In the message text:  lna
The line number.
dev|SNA
Specifies a 4-digit hexadecimal device number for a binary synchronous
communication (BSC) line.  For system network architecture (SNA) lines,
UNIT=SNA.
status
The status of the device. The values for status are:  DRAINED/rname
DRAINING/rname
INACTIVE/rname or nname
ACTIVE/rname or nname
SIGNON/nname
SIGNON/AWAITING-MAS(member-name) nname
SIGNON/AWAITING-ncc or nname

keyword
The name of the keyword.
value
The value of the keyword. See z/OS JES2 Initialization and Tuning Reference  for an explanation
of most keywords.  This keyword might be DISCON={QUIESCE | INTERRUPT
| NO} which is a ‘display only’ keyword.  DISCON= displays the disconnect
status for the line with possible values of:  Value
Meaning
NO
The line is not in the process of disconnecting
QUIESCE
When the current work on the line completes, the line will disconnect
INTERRUPT
The line is interrupting the current transmission and when complete
will disconnect the line.

 The STATUS= keyword displays the current status
of the device. The possible values for status are
listed below, where rname or nname is optionally displayed, indicating the remote name (RMTnnnn) or
node name for which the line is currently in use or permanently assigned.
 In the STATUS= text:  member-name
The name of the member of the local MAS, or list of member names,
from which signon responses are required before the signon can complete.
ncc
The NCC record type (J, K, or L) next expected from node nname to allow the signon to continue.

System action
 Processing continues.

Operator response
 None.

Module
 HASCSCAN
 Routing Code: #/1,2,10
 Descriptor Code: –,4