$HASP221

applid

Explanation

>>-BIND RECEIVED FROM--applid--REJECTED – –--------------------->

>--+-NO IDLE LINES AVAILABLE, RC=01-----------------+----------><
   +-DEDICATED LINE LINElna IS NOT AVAILABLE, RC=02-+   
   +-APPLID NOT DEFINED, RC=03----------------------+   
   '-NETWORK PATH MANAGER IS NOT AVAILABLE, RC=04---'   

 A BIND RU has been received from another NJE
node attempting to establish a session with the local node. The BIND
cannot be accepted because JES2 could not locate a qualifying SNA
line device control table (DCT).
 In the message text:  applid
The VTAM® application identifier of the node.

 The texts have the following meanings:  NO IDLE LINES AVAILABLE, RC=01  No qualifying lines
in the SNA idle line DCT.

DEDICATED LINE LINElna IS NOT AVAILABLE,
RC=02  Dedicated line number lna is not
in the SNA idle line DCT.
  Dedicated line number lna is also dedicated to an RJE device (RMT5,LINE=5).
  Dedicated
line number lna is in disconnect process (draining).
  Dedicated line number lna has a "password"
set on it.
  User has multiple SNA paths to NODE5 and has set
the node for the dedicated line instead of setting the associated
APPL statement for a dedicated line.

APPLID NOT DEFINED, RC=03  Application not defined by
an APPL(avvvvvvv) statement.

NETWORK PATH MANAGER IS NOT AVAILABLE, RC=04  JES2 could
not start the connect because the network path manager PCE failed.
 JES2 issues $HASP502 to indicate this condition.

System action
 The BIND is rejected.

Operator response
 Start a qualifying SNA line with the $S command
and have the other node reenter the $SN command or enter the $SN command
locally to start networking with applid specified in the message
text.

System programmer response
 For RC=02, reason 1, 2, or 3, this
line cannot be used for SNA/NJE line dedication.  Another line must
be used.  For RC=02, reason 4, turn off the password to this line
or use another line.  For RC=02, reason 5, dedicate the line on the
APPL definition instead of the NODE definition. For RC=03, ensure
that the application names defined to JES2 NJE with the APPL(avvvvvvv) or N(nnnn) initialization
parameters are the same as those defined to VTAM and
all other JES2 NJE nodes in the network. If not, correct the APPL(avvvvvvv) or N(nnnn) statement in error
and retry starting networking to the node.

Module
 HASPSNA
 Routing Code: 8,10
 Descriptor Code: 4