$HASP628

devname

Explanation

>>- devname - Start failed - reason----------------------------><

The operator attempted to start the devname device that is specified in the message. The device
could not be started because of the reason listed.
 In the message
text, devname is the device that the operator attempted
to start.
In the message text, reason is
the following reason for the failure:  MOD=CLASS= value is not valid 
A $S OFFLOADx,TYPE=RECEIVE command failed. The offload job receiver
specified a MOD=CLASS= value that is either a nonexistent class, or
an existing class that is currently set to ACTIVE=NO. The value for
MOD=CLASS= must be updated to a valid job class before the offload
device can be started.

System action
 The start command fails.

Operator response
 Contact your system programmer.

System programmer response
 Perform the corrective action described
for the applicable reason, and then retry the start
command.

Module
 HASPCOMM
 Routing Code: #
 Descriptor Code: -