Use these steps to dynamically add an IBM® 10GbE RoCE Express® interface.
Procedure
Perform the following steps:
- Install and configure the 10GbE RoCE Express feature in the hardware configuration
definition (HCD). Configuration includes the physical network
ID (PNet ID) for the 10GbE RoCE Express port.
For more information, see Physical network considerations.
- Add the new PCI Express function
ID (PFID) to the GLOBALCONFIG SMCR parameter in the TCP/IP profile
data set.
Rule: In addition
to the PFID that you are adding, you must also specify all currently
configured PFIDs on the GLOBALCONFIG SMCR parameter. When you update
the configured PFIDs on the GLOBALCONFIG SMCR parameter, you are completely
replacing the configured PFID information.
- Issue the VARY TCPIP,,OBEYFILE command and specify the
updated TCP/IP profile data set.
Results
If any SMC-R capable IPAQENET and IPAQENET6 interfaces were
ever active, the 10GbE RoCE Express interface
that the added PFID represents is automatically started. Otherwise,
the interface is started when the first SMC-R capable interface is
started.