The MODIFY
procname,RECONFIG command
is used to reread the OMPROUTE configuration file. This command accepts
and applies only statements of the following types that have been
added to the configuration file since the last time the file was read:
- OSPF_INTERFACE
- RIP_INTERFACE
- INTERFACE
- IPV6_OSPF_INTERFACE
- IPV6_OSPF (ROUTERID parameter only)
- IPV6_RIP_INTERFACE
- IPV6_INTERFACE
These configuration statements must be reread from the configuration
file using the MODIFY procname,RECONFIG
command before the interfaces to which they refer are defined to the
TCP/IP stack. If you have coded GLOBAL_OPTIONS IGNORE_UNDEFINED_INTERFACES=YES
in your OMPROUTE configuration file, you can use OMPROUTE reconfiguration
to add a definition for an interface that has already been configured
in the stack but ignored by OMPROUTE. However, OMPROUTE does not associate
the interface with the new definition until the interface has been
deleted from the stack and re-added.
Restriction: The IPV6_OSPF statement (ROUTERID parameter
only) is recognized by this command only if there is no existing IPv6
OSPF router ID value set in OMPROUTE. This command cannot be used
to change the value of an existing IPv6 OSPF router ID.