The following commands are used to start, stop, or change the level
of OMPROUTE tracing and debugging:
- MODIFY <procname>,TRACE=n : for OMPROUTE tracing for initialization
and IPv4 routing protocols; n can be 0–2.
- MODIFY <procname>,DEBUG=n : for OMPROUTE debugging for initialization
and IPv4 routing protocols; n can be 0–4.
- MODIFY <procname>,SADEBUG=n : for OMPROUTE subagent debugging;
n can be 0 or 1.
- MODIFY <procname>,TRACE6=n : for OMPROUTE tracing for IPv6
routing protocols; n can be 0–2.
- MODIFY <procname>,DEBUG6=n : for OMPROUTE debugging for
IPv6 routing protocols; n can be 0–4.
Tip: Use of OMPROUTE tracing and debugging affects OMPROUTE
performance and might require increasing the Dead_Router_Interval
on OSPF interfaces to keep neighbor adjacencies from collapsing.