If the resolver is stopped for any reason, manually restart
the resolver.
Before you begin
When you start the resolver, specify REUSASID=YES on the START
command to ensure that a reusable ASID is used. If the resolver address
space is stopped enough times and you do not specify REUSASID=YES,
when you restart the resolver, all available ASIDs might be exhausted,
which prevents the creation of a new address space on the system.
If a new address space is not created on the system, an IPL is required.
For more information about tuning parameters for the maximum number
of ASIDs on a system, see the MAXUSER parameter in
z/OS MVS Initialization and Tuning Reference.
Procedure
Perform one of the following steps to restart the resolver:
- If you have not customized the resolver (you have not created
a start procedure and you have not defined the address space), then
issue the following system operator command:
START IEESYSAS.RESOLVER,PROG=EZBREINI,SUB=MSTR,REUSASID=YES
- If you have customized the resolver, issue one of the following
system operator commands, where procname is
the name of the PROCLIB member that you created:
START procname,REUSASID=YES
START procname,SUB=MSTR,REUSASID=YES