EZD1825I

Explanation
 The Communications Server SMTP (CSSMTP) application
is ending because JES2 or  JES3 subsystems are no longer available. 
 In
the message text:  jobname
The job name of the task that started the CSSMTP application. 

System action
 The CSSMTP application ends.

Operator response
 If the JES2 or JES3 subsystem was not stopped,
contact the system programmer. If the system programmer indicates
that more information is required in the CSSMTP log file, restart
CSSMTP with the minimum value LOGLEVEL,LEVEL=95 configured in the
main configuration file. If the JES2 or JES3 subsystems were stopped,
restart them before restarting CSSMTP.

System programmer response
 Examine the log file to determine
the cause of the problem. Take the necessary corrective action and
restart CSSMTP. If you need more information to diagnose the errors,
restart CSSMTP with the minimum value LOGLEVEL,LEVEL=95. If the log
shows SAPI rc=0 SSOBRETN=32 SSS2REAS=36 and the JES2 DESTDEF statement
specifies NODENAME=REQUIRED, you must define the writer name specified
in the ExtWrtName statement to JES2. You can dynamically define it
to JES using the command
 $ADD DESTID(xxxxxxxx),DEST=xxxxxxxx,
 where
xxxxxxxx is the wtrName value specified in the
ExtWrtName statement. See z/OS JES2 Initialization and Tuning Reference for information about the DESTDEF statement.
To permanently add the destination, use the JES initialization DEStid
statement: DESTID(xxxxxxxx) DEST=xxxxxxxxx. See DEStid(xxxxxxxx)
- Route Code Name in z/OS JES2 Initialization and Tuning Reference for information about the DESTID JES2 statement.
See the information about gathering diagnostic
information about CSSMTP  problems in z/OS Communications Server: IP Diagnosis Guide to determine what documentation you should
obtain before contacting IBM® Service.

User response
 Not applicable.

Problem determination
 See the system programmer response.

Source
 z/OS® Communications
Server TCP/IP: CSSMTP

Module
 ezamlmn

Routing code
 10

Descriptor code
 12

Automation
 This message is written to the system console and
log file for CSSMTP. This message is a good candidate for automation.
Automation can alert you to when CSSMTP shuts down abnormally.

Example
  EZD1825I CSSMTP1 JES NOT AVAILABLE