EZD1069I

Explanation
 An IKE policy list failed to be successfully built,
therefore none of the  policy list changes will be performed for this
stack.  This message indicates  that the IKE policy lists were not
updated because a  failure was detected when  building an IKE policy
list.  All the policy lists that were successfully built  will be
deleted and this stack will use the prior policy information.  Also,
an  EZD1071I message can be found in syslog for the IKE policy list
that could not  be built. There might be EZD1070I messages for each
of the IKE policy lists that  were successfully built (these lists
are deleted when the build error is  detected for an IKE policy list).
 stackname is
the name of the stack for which the policy update failed.

System action
 IKE policy information will not be updated; IKE
daemon processing continues.

Operator response
 You can use the MODIFY REFRESH command to
modify the PAGENT policy information,  which will cause the IKE daemon
to receive an asynchronous notification of the changes to  policy
information.  Then verify that an EZD1068I message is reported on
the  console or in syslog to indicate that the IKE policy information
was successfully updated for this stack.  If the problem persists,
contact the  system programmer.

System programmer response
 The failure might be the result of
IKED not having RACF® authority
to access the policies. See Steps for authorizing
the IKE daemon to RACF in z/OS Communications Server: IP Configuration
Guide for more information. Otherwise, contact IBM® software support services and
provide a syslog that includes this  message.  If available, provide
a CTRACE for component SYSTCPIK.

Module
 policymgr.cpp

Procedure name
  PMConnect
function or policyAsync exit