EZB3825T

Explanation
A UDP port number for the service name was not  assigned
in the tcpip.v3r1.ETC.SERVICES data set. 

System action
NCPROUTE exits.

Operator response
None.

System programmer response
Verify that the tcpip.v3r1.ETC.SERVICES data set has two entries
in the form: 
ncproute
port/udp
router
port/udp

 The entries must start in column 1 and be in lowercase. Verify
that the NCPROUTE service port number is the port being used by the
NCP clients.  The port value defined in the UDPPORT= keyword on the
IPOWNER statement in the NCP generation definition must match the
NCPROUTE service port. The default is UDP port 580.

The reserved router service port number is 520 and is required
for the NCPROUTE transport of RIP packets to NCP clients, which are
responsible for broadcasting the packets to other RIP routers.  The
router service port number cannot be overridden as a result of an
NCP restriction.

Also, verify that port 580 has been reserved for NCPROUTE under
the PORT statement in the tcpip.v3r1.PROFILE.TCPIP data set.

Module
NRMAIN

Procedure name
main 