EZB0674I

hlq

Explanation
The program name specified in the program parameter of
the EXIT statement in the hlq.LPD.CONFIG data set could not be accessed.
This parameter specifies the name of the program to be invoked after
allocating and opening, but before closing, an output data set. This
message is displayed when the END parameter was specified with the
EXIT statement.

System action
LPD continues.

Operator response
None.

System programmer response
Verify that the correct program name was specified in the program parameter
of the EXIT statement in the hlq.LPD.CONFIG data set and restart
the program.

The library containing the program should be in the system's
link list, (LNKLSTxx) or a STEPLIB definition can be
used if the library is APF authorized.

Module
LPD

Procedure name
PreparePrinters 