Parameters

ON: Turns on debug tracing for the VTAM® capture point. The bulk of trace entries are WTOs with ROUTECDE=(11). They go to the JES message log for the VTAM capture point job and to the SYSLOG. Normally, the main operator console is not set up to receive any "programmer information" type Route Code 11 WTOs. TRACE ON will also SNAP out data to the EZAPPSNP DD if it is added to the startup procedure for the VTAM capture point EZAPPAAA. This DD is similar to EZAPPLOG and can be defined to go to SYSOUT=*.
OFF: Turns off debug tracing for the VTAM capture point. The VTAM capture point debugging trace is normally off. After the trace has been dynamically started using the TRACE ON reply to the EZY0837I message, you can turn it off with the TRACE OFF command.