The hlq.TCPIP.DATA data set

For IMS™, you do not have to make any extra entries in hlq.TCPIP.DATA. However, you need to check the TCPIPJOBNAME parameter that was entered during TCP/IP Services setup. This parameter is the name of the started procedure used to start the TCP/IP MVS™ address space. This must match the job name in the Listener configuration file TCPIP statement, as described in TCPIP statement. In the example shown in Figure 1, TCPIPJOBNAME is set to TCPV3. The default name is TCPIP.

Figure 1. The TCPIPJOBNAME Parameter in the DATA data set

 ;***********************************************************************
 ;                                                                      *
 ;   Name of Data Set:      hlq.TCPIP.DATA                              *
 ;                                                                      *
 ;   This data, TCPIP.DATA, is used to specify configuration            *
 ;   information required by TCP/IP client programs.                    *
 ;                                                                      *
 ;***********************************************************************
 ; TCPIPJOBNAME specifies the name of the started procedure which was
 ; used to start the TCP/IP address space.    TCPIP is the default.
 ;
 TCPIPJOBNAME TCPV3
        ..........
        ..........
        ..........