EZZ9296I

Explanation
 The resolver issues this message when
it is unable to access an MVS™ data
set or  a z/OS® UNIX file during the initialization of the resolver
address space or while processing a MODIFY RESOLVER,REFRESH,SETUP
command. 
In the message text: filename
The name of the data set or file that the resolver was unable
to access.If this message was generated during initialization of the resolver
address space, filename is the resolver setup file.
If this message was generated while processing a MODIFY RESOLVER,REFRESH,SETUP
command, filename can be either the resolver setup
file specified on the SETUP operand, or a data set or file specified
on a resolver setup statement.

rc
The return code and is one of the following values:  Return code (hexadecimal)
Meaning
Corrective action for
the file specified by the filename value
00080004
File or data set not allocated.
Ensure that filename exists. 
00080008
Open failed.
Ensure that the specified MVS data
set, PDS member, or z/OS UNIX file exists and is accessible
to the resolver.
Examine the JES message log (JESMSGLG). If the JESMSGLG
contains the message OMVS SEGMENT NOT DEFINED
define
an OMVS segment for the resolver address space.

0008000C
Record format of MVS data
set is not supported.
Ensure that the filename value
is an MVS data set that has a
record format F or FB, or is a member specified in the PDS data set.
00080010
Data set in use.
Ensure that the specified MVS data set is not allocated by another job.
00080024
Insufficient storage to allocate and open file.
Increase the region size for the resolver.
0010xxxx
Dynamic allocation failed.
See z/OS MVS Programming: Authorized Assembler Services
Guide and perform the corrective actions listed
in the DYNALLOC error reason code table for SVC99 error code xxxx.

System action
 If this message was generated during the initialization of the
resolver address space, processing continues. The resolver initializes
with the default configuration settings.
If this message was generated while a MODIFY RESOLVER,REFRESH,SETUP
command was processing, the MODIFY command is ignored. 

Operator response
 Contact the system programmer.

System programmer response
 See the table in the explanation
section for the corrective actions to take. If this message was generated during the initialization of the
resolver address space and the resolver setup file has been corrected,
instruct the operator to issue a MODIFY RESOLVER,REFRESH,SETUP command
to correct the resolver configuration.
If this message was generated while a MODIFY RESOLVER,REFRESH,SETUP
command was processing and the file specified by the filename value
has been corrected, instruct the operator to issue the MODIFY command
again.

Problem determination
None.

Source
z/OS Communications
Server TCP/IP: System Resolver

Module
 EZBRECFG

Routing code
2, 8

Descriptor code
5

Automation
This message is displayed at the operator
console and is suitable for automation. You can use it to detect resolver
initialization problems that impact your system.