EZZ8158I

Explanation
 This message was issued because OMPROUTE could
not establish an adjacency with a neighbor on the interface specified
by the interface1 value.  The neighbor is identified
in message EZZ8157I.    OMPROUTE found a redundant parallel interface
(interface2)  that can reach the  same neighbor
on the LAN and OMPROUTE is attempting to establish  an adjacency 
with the neighbor.   OMPROUTE will change interface1 to
SUSPEND state and  interface1 will remain in that
state until the interface is recycled or is dynamically activated
to allow an adjacency to be established. 
 In the message text: jobname
The name of the OMPROUTE application.
ipversion
The IP version that OSPF is running. Possible values for ipversion are:
 IPv6
OSPF for IPv6
IPv4
OSPF for IPv4

interface1
The name of the local interface over which OMPROUTE failed to
establish an adjacency.
interface2
The name of the redundant parallel interface over which OMPROUTE
will now attempt to establish an adjacency.

System action
 OMPROUTE continues and will attempt to establish
an adjacency with the neighbor over the  redundant parallel interface.

Operator response
 Contact the system programmer.

System programmer response
 If connectivity problems persist,
investigate the reason that the adjacency  could not be established.
 Inspect the remote networking hardware components,  such as routers,
switches, or cabling, that might contribute to the problem.

User response
 Not applicable.

Problem determination
 See the system programmer response.

Source
 z/OS® Communications
Server TCP/IP: OMPROUTE

Module
 SPFNBR, EZA6RSPB

Routing code
 10

Descriptor code
 12

Automation
 This message goes to the console or syslog.

Example
  EZZ8158I OMPROUTE IPv4 OSPF could not establish adjacency on interface OSAGBE1  - attempting to 
         establish adjacency on interface OSAGBE2 