EZZ0828I

Explanation
 The specified parameter cannot be used on a VIPADISTRIBUTE
DEFINE statement when the HOTSTANDBY distribution method is specified.
 The parameter is ignored.
 In the message text:  
parm
The parameter on the VIPADISTRIBUTE DEFINE statement
linenum
The line number in the configuration file on which the parameter
is specified

System action
 If processing an initial profile or
VARY TCPIP,,OBEYFILE command, TCP/IP continues. The VIPADISTRIBUTE
DEFINE statement is accepted, but the parameter is ignored.
This message is also displayed as part of VARY TCPIP,,SYNTAXCHECK
processing when the VARY TCPIP,,SYNTAXCHECK command detects this error
in a profile data set. No changes are applied to the active configuration
by VARY TCPIP,,SYNTAXCHECK processing.

Operator response
 Contact the system programmer.

System programmer response
 Take the following steps
to correct the problem:Remove the specified parameter from the VIPADISTRIBUTE DEFINE
statement.
If this message was displayed as a result of a VARY TCPIP,,SYNTAXCHECK
command, issue the command again to verify that you have removed all
syntax errors from the profile. Otherwise, issue a VARY TCPIP,,OBEYFILE
command using this profile.

User response
 Not applicable.

Problem determination
 Not applicable.

Source
 z/OS® Communications
Server TCP/IP: Configuration & Initialization

Module
 EZACFPVA

Routing code
 10

Descriptor code
 12

Automation
 This message is directed to the console.
You can use automation to detect and respond to TCP/IP profile errors
reported during initial profile and VARY TCPIP,,OBEYFILE processing.
This message can also be displayed  during VARY TCPIP,,SYNTAXCHECK
processing. Because the VARY TCPIP,,SYNTAXCHECK command does not affect
the active configuration, you might want to adjust your automation
to ignore the configuration messages that are displayed after  EZZ0061I
and before EZZ0065I.

Example
  EZZ0828I VIPADISTRIBUTE TIMEDAFFINITY ON LINE 5 IS IGNORED WHEN DISTMETHOD IS  HOTSTANDBY                           