EZZ0814I

Explanation
 The specified parameter cannot be used on a VIPADISTRIBUTE
DEFINE statement  that specifies an IPv6 interface. The specified
parameter cannot be used for  IPv6 processing. 
In the message
text:  
parm
The parameter on the VIPADISTRIBUTE DEFINE statement
linenum
The line number in the configuration file on which the parameter
is specified

System action
 If processing an initial profile or
a VARY TCPIP,,OBEYFILE command, TCP/IP continues, but the VIPADISTRIBUTE
statement is ignored.
This message is also displayed
as part of VARY TCPIP,,SYNTAXCHECK processing when the VARY TCPIP,,SYNTAXCHECK
command detects this error in a profile data set. No changes are applied
to the active configuration by VARY TCPIP,,SYNTAXCHECK processing.

Operator response
 Contact the system programmer.

System programmer response
 Do the following steps to correct
the problem:  
 Remove the specified parameter from the VIPADISTRIBUTE DEFINE
statement or  change the IPv6 interface to an IPv4 address.  
If this message was displayed as a result of a VARY
TCPIP,,SYNTAXCHECK command, issue the command again to verify that
you have corrected all syntax errors in the profile. Otherwise, issue
the VARY TCPIP,,OBEYFILE command with the changed VIPADYNAMIC block. 
See the information about the VIPADYNAMIC
statement in z/OS Communications Server: IP Configuration
Reference.

User response
 Not applicable.

Problem determination
 Not applicable.

Source
 z/OS® Communications
Server TCP/IP: Configuration & Initialization

Module
 EZACFPVA

Routing code
 8

Descriptor code
 12

Automation
 This message is directed to the console.
You can use automation to detect and respond to TCP/IP profile errors
reported during initial profile and VARY TCPIP,,OBEYFILE processing.
This message can also be displayed during VARY TCPIP,,SYNTAXCHECK
processing. Because the VARY TCPIP,,SYNTAXCHECK command does not affect
the active configuration, you might want to adjust your automation
to ignore the configuration messages that are displayed after EZZ0061I
and before EZZ0065I.

Example
  EZZ0814I VIPADISTRIBUTE CONTROLPORT ON LINE 35 CANNOT BE SPECIFIED WITH AN IPV6  INTERFACE