EZZ0809I

Explanation
 The specified parameter is not valid for this
configuration statement when the  TIER1, TIER2, or CPCSCOPE parameter
is specified on the same statement. The parameter is ignored.
 In
the message text:
stmt
The VIPADYNAMIC block statement
parm
The parameter on the specified statement
linenum
The line number in the configuration file on which the parameter
is specified

System action
 If processing an initial profile or
a VARY TCPIP,,OBEYFILE command, TCP/IP continues. The statement is
processed but the specified configuration parameter is ignored. 
This message is also displayed as part of VARY TCPIP,,SYNTAXCHECK
processing when the VARY TCPIP,,SYNTAXCHECK command detects this error
in a profile data set.  No changes are applied to the active configuration
by VARY TCPIP,,SYNTAXCHECK processing.

Operator response
 Contact the system programmer.

System programmer response
 Do the following steps to correct
the problem:   
 Remove the specified parameter from the VIPABACKUP or VIPADEFINE
statement or remove the TIER1, TIER2, or CPCSCOPE parameter. 
If this message was displayed as a result of a VARY
TCPIP,,SYNTAXCHECK command, issue the command again to verify that
you have corrected all syntax errors in the profile.Otherwise,
do the following:If you removed the TIER1, TIER2 or CPCSCOPE parameter, issue a
VIPADELETE command for the DVIPA. 
Issue the VARY TCPIP,,OBEYFILE command with the changed VIPADYNAMIC
block.

See the information about the VIPADYNAMIC
statement in z/OS Communications Server: IP Configuration
Reference.

User response
 Not applicable.

Problem determination
 Not applicable.

Source
 z/OS® Communications
Server TCP/IP: Configuration & Initialization

Module
 EZACFPVA

Routing code
 8

Descriptor code
 12

Automation
 This message is directed to the console.
 You can use automation to detect and respond to TCP/IP profile errors
reported during initial profile and VARY TCPIP,,OBEYFILE processing.
This message can also be displayed during VARY TCPIP,,SYNTAXCHECK
processing.  Because the VARY TCPIP,,SYNTAXCHECK command does not
affect the active configuration, you might want to adjust your automation
to ignore the configuration messages that are displayed after EZZ0061I
and before EZZ0065I.

Example
  EZZ0809I VIPADEFINE SERVICEMGR PARAMETER ON LINE 35 IGNORED WHEN TIER1, TIER2 OR CPCSCOPE ARE SPECIFIED