Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
EZZ0801I z/OS Communications Server: IP Messages Volume 4 (EZZ, SNM) SC27-3657-01 |
|
EZZ0801I VIPADISTRIBUTE PROCTYPE PARAMETER WITH ALL VALUES SET TO
ZERO IS NOT VALID ExplanationThe VIPADISTRIBUTE statement PROCTYPE parameter values must not all be configured to the value 0. System actionIf processing an initial profile or a VARY TCPIP,,OBEYFILE command, TCP/IP continues, but the VIPADISTRIBUTE statement is ignored. This message is also displayed as part of VARY TCPIP,,SYNTAXCHECK processing when the VARY TCPIP,,SYNTAXCHECK command detects this error in a profile data set. No changes are applied to the active configuration by VARY TCPIP,,SYNTAXCHECK processing. Operator responseContact the system programmer. System programmer responseTo change the PROCTYPE parameter values, do the following steps:
User responseNot applicable. Problem determinationNot applicable. Sourcez/OS® Communications Server TCP/IP ModuleEZACFPVA Routing code8 Descriptor code12 AutomationThis message is directed to the console. You can use automation to detect and respond to TCP/IP profile errors reported during initial profile and VARY TCPIP,,OBEYFILE processing. This message can also be displayed during VARY TCPIP,,SYNTAXCHECK processing. Because the VARY TCPIP,,SYNTAXCHECK command does not affect the active configuration, you might want to adjust your automation to ignore the configuration messages that are displayed after EZZ0061I and before EZZ0065I. ExampleThe following
VIPADISTRIBUTE statement would be rejected because PROCTYPE was specified
with all values equal to 0:
|
Copyright IBM Corporation 1990, 2014
|