z/OS Communications Server: IP Messages Volume 4 (EZZ, SNM)
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


EZZ0798I

z/OS Communications Server: IP Messages Volume 4 (EZZ, SNM)
SC27-3657-01

EZZ0798I
VIPADISTRIBUTE WITH BOTH DESTIP ALL AND WEIGHT KEYWORD IS REJECTED FOR dvipa

Explanation

Both the DESTIP ALL keyword and the WEIGHT keyword were specified on the same VIPADISTRIBUTE statement. The WEIGHT and ALL keywords are mutually exclusive keywords on the VIPADISTRIBUTE statement.

In the message text:

dvipa
The IPv4 address or the IPv6 interface name specified on the VIPADISTRIBUTE statement

System action

If processing an initial profile or a VARY TCPIP,,OBEYFILE command, TCP/IP continues, but the VIPADISTRIBUTE statement is ignored.

This message is also displayed as part of VARY TCPIP,,SYNTAXCHECK processing when the VARY TCPIP,,SYNTAXCHECK command detects this error in a profile data set. No changes are applied to the active configuration by VARY TCPIP,,SYNTAXCHECK processing.

Operator response

Contact the system programmer.

System programmer response

  1. Change the VIPADISTRIBUTE statement in one of the following ways:
    • Remove the WEIGHT keyword (and associated value).
    • Explicitly list each target system with their associated WEIGHT keywords.
  2. If this message was displayed as a result of VARY TCPIP,,SYNTAXCHECK processing, issue the command again to verify that you have corrected all syntax errors in the profile. Otherwise, issue a VARY TCPIP,,OBEYFILE command with the updated profile.

User response

Not applicable.

Problem determination

Not applicable.

Source

z/OS® Communications Server TCP/IP

Module

EZACFPVA

Routing code

8

Descriptor code

12

Automation

This message is directed to the console. You can use automation to detect and respond to TCP/IP profile errors reported during initial profile and VARY TCPIP,,OBEYFILE processing.

This message can also be displayed during VARY TCPIP,,SYNTAXCHECK processing. Because the VARY TCPIP,,SYNTAXCHECK command does not affect the active configuration, you might want to adjust your automation to ignore the configuration messages that are displayed after EZZ0061I and before EZZ0065I.

Example

The following VIPADISTRIBUTE statement is rejected because both the ALL and WEIGHT keywords are specified: 
VIPADISTRIBUTE  201.2.10.11  PORT 4011  DESTIP ALL  WEIGHT 20
VIPADISTRIBUTE DISTMETHOD WEIGHTEDACTIVE 201.2.10.11 PORT 4011 DESTIP ALL WEIGHT 20
Parent topic: EZZ0xxxx messages

Go to the previous page Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites



Copyright IBM Corporation 1990, 2014