EZZ0782I

Explanation
 The DESTIP ALL parameter cannot be specified on
a VIPADISTRIBUTE DEFINE statement if ENCAP is specified.  
 In
the message text: linenum
The line number in the configuration file on which the ENCAP parameter
is specified

System action
 If processing an initial profile or
a VARY TCPIP,,OBEYFILE command, TCP/IP continues, but the VIPADISTRIBUTE
DEFINE statement is ignored.
This message is also
displayed as part of VARY TCPIP,,SYNTAXCHECK processing when the VARY
TCPIP,,SYNTAXCHECK command detects this error in a profile data set.
 No changes are applied to the active configuration by VARY TCPIP,,SYNTAXCHECK
processing.

Operator response
 Contact the system programmer.

System programmer response
 To correct the problem, do one of the following:    Change the VIPADISTRIBUTE DEFINE statement to specify the DESTIP
parameter with specific IPv6 addresses.  
Remove the ENCAP parameter.See VIPADYNAMIC
statement in z/OS Communications Server: IP Configuration
Reference for more information.

If this message was displayed as a result of a VARY
TCPIP,,SYNTAXCHECK command, issue the command again to verify that
you have corrected all syntax errors in the profile.  Otherwise, If you removed the ENCAP parameter from the statement,Issue VIPADISTRIBUTE DELETE statements for all previous VIPADISTRIBUTE
DEFINE statements for this DVIPA.
Specify those VIPADISTRIBUTE DEFINE statements again but without
the ENCAP parameter. 

Issue the VARY TCPIP,,OBEYFILE command with the changed VIPADYNAMIC
block.

User response
 Not applicable.

Problem determination
 Not applicable.

Source
 z/OS® Communications
Server TCP/IP: Configuration & Initialization

Module
 EZACFPVA

Routing code
 8

Descriptor code
 12

Automation
 This message is directed to the console.
 You can use automation to detect and respond to TCP/IP profile errors
reported during initial profile and VARY TCPIP,,OBEYFILE processing.
This
message can also be displayed during VARY TCPIP,,SYNTAXCHECK processing.
 Because the VARY TCPIP,,SYNTAXCHECK command does not affect the active
configuration, you might want to adjust your automation to ignore
the configuration messages that are displayed after EZZ0061I and before
EZZ0065I.

Example
  EZZ0782I VIPADISTRIBUTE PARAMETER DESTIP ALL ON LINE 19 CANNOT BE SPECIFIED  WHEN ENCAP IS SPECIFIED 