EZZ0768I

Explanation
 The IPv4 address that was specified is not valid.
 The following IPv4 addresses  are not valid:  Broadcast  (255.255.255.255) 
Class E  (An IPv4 address in the range of 240.0.0.0 - 247.255.255.255)

 In the message text: ipv4_address
The IPv4 address that is not valid
lineno
The line number in the profile where the IP address is found

System action
 If processing an initial profile or
a VARY TCPIP,,OBEYFILE command, TCP/IP continues, but the statement
is ignored. 
This message is also displayed as part
of VARY TCPIP,,SYNTAXCHECK processing when the VARY TCPIP,,SYNTAXCHECK
command detects this error in a profile data set.  No changes are
applied to the active configuration by VARY TCPIP,,SYNTAXCHECK processing.

Operator response
 Contact the system programmer.

System programmer response
Correct the IP address.
Configuration statements and valid IPv4 addresses are described in
the z/OS Communications Server: IP Configuration
Reference.
If this message was displayed
as a result of a VARY TCPIP,,SYNTAXCHECK command, issue the command
again to verify that you have corrected all syntax errors in the profile.
 Otherwise, issue a VARY TCPIP,,OBEYFILE command using this profile.

Module
 EZACFPR2

Automation
This message is directed to the console.
You can use automation to detect and respond to TCP/IP profile errors
reported during initial profile and VARY TCPIP,,OBEYFILE processing.
This
message can also be displayed during VARY TCPIP,,SYNTAXCHECK processing.
 Because the VARY TCPIP,,SYNTAXCHECK command does not affect the active
configuration, you might want to adjust your automation to ignore
the configuration messages that are displayed after EZZ0061I and before
EZZ0065I.

Procedure name
  processSrcIp

Example
 EZZ0768I IPV4 ADDRESS OF 241.1.0.9 ON LINE 23 CANNOT BE SPECIFIED