EZZ0729I

Explanation
 The NETACCESS or VIPARANGE statement has an IPv6
address defined without a prefix length  specified.  All IPv6 addresses
require a prefix length. 
 In the message text: lineno
The line number where the error was found

System action
 If processing an initial profile or
a VARY TCPIP,,OBEYFILE command, TCP/IP continues.
This
message is also displayed as part of VARY TCPIP,,SYNTAXCHECK processing
when the VARY TCPIP,,SYNTAXCHECK command detects this error in a profile
data set.  No changes are applied to the active configuration by VARY
TCPIP,,SYNTAXCHECK processing.

Operator response
Contact the system programmer.

System programmer response
In the profile that had the error, add the prefix length to the
IPv6 address on the NETACCESS or VIPARANGE statement.
If this message was displayed as a result of a VARY TCPIP,,SYNTAXCHECK
command, issue the command again to verify that you have corrected
all syntax errors in the profile. Otherwise, issue a VARY TCPIP,,OBEYFILE
command using this profile.

Module
 EZACFPAR, EZACFPVA

Automation
This message is directed to the console.
You can use automation to detect and respond to TCP/IP profile errors
reported during initial profile and VARY TCPIP,,OBEYFILE processing.
This
message can also be displayed during VARY TCPIP,,SYNTAXCHECK processing.
 Because the VARY TCPIP,,SYNTAXCHECK command does not affect the active
configuration, you might want to adjust your automation to ignore
the configuration messages that are displayed after EZZ0061I and before
EZZ0065I.

Procedure name
  rdparser

Example
 EZZ0729I MISSING REQUIRED /PREFIX ON LINE 47 