EZZ0307I

Explanation
 An error occurred in the configuration component.
 reason_code is
one of the following: -1
Selectex call failed for the Autolog task. The Autolog task will
be shut down.
-4
Internal error occurred. This will be one of the following: The call to get the telnet socket/port failed.
Telnet error when trying to retrieve the stack jobname from TSEB
(no TSEB found.)

-5
Should not occur - internal Telnet error.
-15
Storage obtain failed.
-17
Header contained invalid data. This might be a verson or request
type that is not valid.
-18
Header length invalid.
-20
Bad contact type in header. The contact value must be either INIT_CONTACT,
RECONTACT, or RESYNC. The connection is closed.
-22
Buffer too small to receive data. Input buffer is not large enough
to be a protocol header.
-23
Buffer too small to be valid. Output buffer is not large enough
for a response header.
-24
Bad subtype in buffer. Subtype in response does not match subtype
in request.
-25
Address less than or equal to zero or Telnet client state not
valid to send QUIESCE.
-26
Data in response is invalid. Telnet error in QUIESCE response.
-27
Socket descriptor too large.
-28
Socket descriptor too large.
-50
User tokens were not equal on a RESYNC request.
-52
Maximum number of retries reached for profile processing on RECONTACT.
-60
Cannot fine TSEB in main entry point for configuration subtask.
Configuration task will be shut down.
-61
Cannot fine TSDB in main entry point for configuration subtask.
Configuration task will be shut down.
-62
Cannot fine TSDX in main entry point for configuration subtask.
Configuration task will be shut down.
-63
Socket call failed. Error trying to open the socket to the stack
when processing a start or stop device.
-64
Storage obtain failed. Error when attempting to get a buffer for
ioctl when processing a start or stop device.
-65
Storage obtain failed. Error when attempting to get a buffer for
ioctl when processing initial device.
-66
Storage obtain failed. Error when attempting to get a buffer for
ioctl when processing the VARY TCPIP,,OBEYFILE command.
-67
Setibmopt failed while processing a start or stop device. In order
to have more than one TCP/IP stack connected to z/OS® UNIX,
the z/OS UNIX must be configured for Common INET (CINET.)
Processing is terminated
-68
Autolog initialization failed.
-69
Cannot find TSEB in main entry point for Autolog subtask. Autolog
task will be shut down.
-70
Cannot find TSDB in main entry point for Autolog subtask. Autolog
task will be shut down.
-71
Cannot find TSDX in main entry point for Autolog subtask. Autolog
task will be shut down.
-72
Autolog error recovery failed.

System action
 TCP/IP continues.

Operator response
 Contact the system programmer.

System programmer response
 Correct the error described by error_code.
Report Internal errors to the IBM® software
support center.

Module
 EZACFMMN, EZACFPAR

Procedure name
  main,
handleInitialProfile, processObeyFile