- ddname
- The ddname for an INFILE data set cannot be the same as the ddname
for any other data sets used by SMP/E. Other than this, there are
no restrictions.
- Use
- The INFILE data set is a sequential data set containing a zone
that is to be loaded by the ZONEIMPORT command. The ddname of this
sequential data set is specified on the INFILE operand of the ZONEIMPORT
command. The zone in the INFILE data set can be used in two ways:
- To recreate a zone that was destroyed
- To recreate a zone on another CSI data set
You must use the ZONEEXPORT command to create the INFILE
data set. (This same data set is called the OUTFILE data set when
it is created by the ZONEEXPORT command.)
- Attributes
- Sequential; no DCB parameters are required.
If the INFILE data
set is on tape, there may be more than one volume for an exported
data set. Remember to specify all the volume serial numbers on the
INFILE DD statement.
- Device
- Tape or direct access.
Note: BLKSIZE must not exceed 32760.