Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Processing SMP/E for z/OS Commands SA23-2275-01 |
|
The REPORT SOURCEID command checks the SYSMOD entries in a zone and reports on any source IDs found in those entries. The resulting output can be used to list the SYSMOD entries associated with the source IDs that were found. SMP/E first verifies that each target and distribution zone specified on the ZONES operand is defined in the global zone. The zones and ZONESETs specified on the ZONES operand (including the global zone) are used to create a list of zones to be reported on. For each specified value, SMP/E first checks for a ZONESET with the same name. If none is found, SMP/E checks for a zone with the same name. If a zone is specified separately and is also part of a ZONESET, it is only reported on once. The zones are opened for read access. If NOPUNCH was not specified, the SMPPUNCH data set is also opened. For each zone to be reported on, SMP/E checks all the SYSMOD entries
in that zone to see if they contain source IDs.
SMP/E then writes a SOURCEID report for each zone specified by
the ZONES operand.
In addition, if NOPUNCH was not specified, SMP/E writes commands to the SMPPUNCH data set to list the SYSMODs associated with the source IDs that were found. Finally, SMP/E closes all the data sets. If any of the following occurs, SMP/E issues an error message,
and REPORT SOURCEID processing fails:
|
Copyright IBM Corporation 1990, 2014
|