The following identifies the phases of SET processing and the zones
and data sets SMP/E may require for exclusive or shared use during
each phase. For more information about command phases and data set
sharing in SMP/E, see Sharing SMP/E data sets.
- Initialization
- Global zone
- Read without enqueue.
- Target zone
- Read without enqueue.
- DLIB zone
- Read without enqueue.
Note: The type of zone that is accessed depends on
the zone specified in the SET command.
- Global zone update
- Global zone
- Update with exclusive enqueue.
- SMPPTS
- Update with exclusive enqueue.
- Target zone
- Update with exclusive enqueue.
- DLIB zone
- Update with exclusive enqueue.
Note: - This phase is executed only if the zone type in the SET command
was either a target zone or a distribution zone, and only if that
target zone or distribution zone contained pending global zone updates
from a previous APPLY, ACCEPT, or RESTORE command.
- Either the target zone or distribution zone is accessed, according
to the zone type specified in the SET command.
- Termination
All resources are freed.