Bypassed HOLD reason report

This report is produced at the completion of APPLY or ACCEPT processing to identify HOLD reason IDs that were bypassed on the APPLY or ACCEPT command. When this report is presented for a non-CHECK mode run, it provides confirmation about which HOLD conditions were bypassed.

You can use this report for planning a non-CHECK mode run by taking one of these actions:

Run an APPLY or ACCEPT in CHECK mode and bypass all HOLDSYS and HOLDUSER conditions.
The "Bypassed HOLD Reason Report" is produced for this run and contains all the HOLDs that would be bypassed for SYSMODs that would be applied or accepted successfully.
Review the report and the information contained in the HOLDDATA. From this (and possibly other investigation) you can determine what actions must be taken and which HOLDs can be safely bypassed for the non-CHECK mode run.