Processing after system generation

After a complete system generation, you must copy the distribution zone, using an SMP/E zone utility command (such as ZONECOPY, ZONEEXPORT and ZONEIMPORT, or ZONEMERGE), to the new target zone before doing any JCLIN processing. This makes sure the initial target zone entries match those of the distribution zone and contain entries not created by JCLIN processing.

After a partial system generation (that is, a device generation), the output of stage 1 must be used as input to JCLIN processing to make sure that:

Module, macro, and load module entries in the target zone are updated.
New assembler entries are stored with the new assembler input in the target zone.
Link-edit utility control statements for load module entries are automatically replaced, except for link-edit utility CHANGE and REPLACE control statements.
CHANGE and REPLACE control statements are associated with the DLIB module name found on the next INCLUDE statement in the link-edit job.
- If the same INCLUDE statement is contained in the stage 1 output, the CHANGE and REPLACE control statements are replaced.
- If that INCLUDE statement is not contained in the stage 1 output, the CHANGE and REPLACE control statements are carried over to the updated entry.