SMPPUNCH output

To make it easier for you to install resolving SYSMODs for exception SYSMODs, SMP/E writes the necessary commands to the SMPPUNCH data set: SET BOUNDARY, RECEIVE (for unreceived resolving SYSMODs), RESETRC, and either ACCEPT (for distribution zones) or APPLY (for target zones). Nothing is written to SMPPUNCH for a specified zone in the following cases:

There are no exception SYSMODs for the specified zone.
There are no resolving SYSMODs for any of the exception SYSMODs or all resolving SYSMODs identified are held.
The specified zone is the global zone.
NOPUNCH was specified on the REPORT MISSINGFIX command.

Figure 1 shows the format of the SMPPUNCH output from the REPORT MISSINGFIX command.

Figure 1. REPORT MISSINGFIX: Format of SMPPUNCH Output

SET BDY(GLOBAL).
    RECEIVE ORDER(
    CONTENT(ALL)/*
    CONTENT(PTFS(
               aaaaaaa bbbbbbb ccccccc ddddddd
                 ))
                */
    ORDERSERVER(xxxxxxxx)
    CLIENT(yyyyyy)
                 )
    DELETEPKG.
SET BDY(tgtzone).
    APPLY CHECK
    SELECT(
    /*fix category*/
           eeeeeee
           fffffff
          )
   BYPASS(HOLDSYSTEM)
	GROUPEXTEND.

zone: is the name of the target or distribution zone in which the exception SYSMOD is currently installed.
command: is the command to be used to install the resolving SYSMODs: ACCEPT for a distribution zone, APPLY for a target zone.
aaaaaaabbbbbbbccccccc: is the ID of a resolving SYSMOD that has not been received.