Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Mass-mode processing SMP/E for z/OS Commands SA23-2275-01 |
|
In mass-mode processing, SMP/E selects only SYSMODs that have not
been applied or accepted anywhere. First, SMP/E checks each SYSMOD
to see if it meets the requirements defined by the operands specified
on the REJECT command.
Next, SMP/E determines which of these SYSMODs have not been applied
or accepted anywhere. To do this, it checks all the target and distribution
zones defined by zone index subentries, minus any zones or ZONESETs
specified on the EXCLUDEZONE operand. For each specified value, SMP/E
first checks for a ZONESET with the same name. If none is found, SMP/E
checks for a zone with the same name. If a SYSMOD is not installed in
any of the zones that were checked, it may be rejected.
Note: A SYSMOD
is considered installed if the ERROR indicator in its entry is off,
or if it has been superseded. A deleted SYSMOD is not considered installed.
Each SYSMOD that meets all the specified conditions is eligible
to be rejected.
Note: Superseded SYSMODs are rejected in mass mode
only if the EXCLUDEZONE operand specifies the zone where the SYSMOD
is superseded. EXCLUDEZONE cannot exclude all target and distribution
zones from processing.
Deleted SYSMODs are rejected in mass mode provided they are eligible, regardless of whether EXCLUDEZONE is specified. No HOLDDATA entries are deleted during Mass-mode processing. If the HOLDDATA operand is specified, it is ignored. When a SYSMOD entry is deleted, its internal SYSTEM HOLDDATA entries are not deleted, but are retained in the global zone. |
Copyright IBM Corporation 1990, 2014
|