Batch submit batch data set compare

Option B causes SuperC to process the data sets in batch mode. This choice frees the keyboard, allowing you to continue using ISPF while waiting for SuperC to compare the data sets. The output listing is sent to the destination specified on the SuperC Utility - Submit Batch Jobs panel (Figure 1).

The panel shown in Figure 1 is displayed if you select option B and leave the New DS Name or Old DS Name field blank on the SuperCE Utility panel. You can concatenate up to four data sets that have like attributes. For example, all must be either sequential or partitioned.

Figure 1. SuperCE - Concatenation Batch Entry panel (ISRSECAT)

                     SuperCE - Concatenation Batch Entry

                               "New" Concatenation
    DS1 . . .                                                        
    DS2 . . .                                                        
    DS3 . . .                                                        
    DS4 . . .                                                        

                 Other "New" Partitioned, Sequential or VSAM Data Set
 Data Set Name . . .                                                        
 Volume Serial . . .           (If not cataloged)
 Password  . . . . .           (Password allowed only in foreground mode)

                               "Old" Concatenation
    DS1 . . .                                                        
    DS2 . . .                                                        
    DS3 . . .                                                        
    DS4 . . .                                                        

                 Other "Old" Partitioned, Sequential or VSAM Data Set
 Data Set Name . . .                                                        
 Volume Serial . . .           (If not cataloged)
 Password  . . . . .           (Password allowed only in foreground mode)
 Command ===>                                                                 
  F1=Help      F2=Split     F3=Exit      F7=Backward  F8=Forward   F9=Swap
 F12=Cancel

This panel is the same as the panel shown in Figure 1, except the Password field is omitted. If your data sets are password protected, compare the data sets in foreground mode by leaving the Option field on the SuperCE Utility panel blank.