The SCLM SREPLACE command is similar to the ISPF Edit REPLACE command except that the SCLM editor automatically parses, locks out, and creates an accounting record for the replaced member. Use this command, not SCREATE, when the member exists in the group.

If you do not enter a change code on the SCLM Edit Entry panel (when it is required), SCLM displays the SCLM Edit Profile panel shown in Figure 1. Also, the replaced member has the same member attributes as the current member.

If you use SREPLACE and specify a member that does not exist, SCLM calls SCREATE by default so that you can create the member.

If the member your are editing has a language that specifies ENCODE=Y, when saving the new member, SCLM will encode the member. For more information, see Member encoding and decoding.

The SCLM SREPLACE command does not offer an extended panel for replacing a member outside the hierarchy.

The label parameters indicate the lines from which the current member is replaced by the replaced member. The label parameters are optional.

>>-+-SREPLACE-+--member-name--+--------+-----------------------><
   '-SREPL----'               +-label1-+   
                              '-label2-'   

To see an example of using commands with labels, see SCREATE command.