This section illustrates a successful build operation. Because all members are not affected by the change to the FLM01EQU member, only the members containing FLM01EQU are recompiled and linked. SCLM processes project components efficiently by recompiling and relinking only those modules that were altered since the last build operation.

1. Select Build from the SCLM Main Menu and press Enter.
2. On the Build panel, type:

   DEV2

   in the Group field

   ARCHDEF

   in the Type field

   FLM01AP1

   in the Member field

   1

   in the Mode field

   2

   in the Scope field

   1

   in the Messages field

   1

   in the Report field

   3

   in the Listings field

3. Press Enter.
4. Note that:
   • The traversal of the architecture FLM01MD2 was not affected by the change to the FLM01EQU member and will not be recompiled. FLM01LD2, which contains only FLM01MD2, will not be relinked.
   • FLM01CD7 was not affected by the change to the FLM01EQU member and will not be recompiled. FLM01LD7, which contains only FLM01CD7 and FLM01CD8, will not be relinked.
5. Verify that the build completed successfully (RETURN CODE = 0). If the return code is not zero, check the listing, correct the errors, and try again.