Removing encoding and decoding

To remove the encoding for a language, perform these steps:

Modify the language translator to specify ENCODE=N.
For all members with the language in question, you must run the ENDEC service to decode the members at all levels in the hierarchy.
For each of the members with that language, you must run the ENDEC service on the associated version PDS members at all levels in the hierarchy.

For the SCLM outputs, if the ENCODE=Y parameter on the FLMALLOC macro is modified or removed from a language translator, the non-editable member is not required to be decoded unless:

SCLM users require SCLM output to be in a decoded state.
The SCLM project does not have any SCLM language translators with an ENCODE=Y parameter specified on the FLMALLOC macro. In this case, SCLM does not know that SCLM project contains any encoded SCLM outputs and so encoded output members are not viewable from within SCLM.