Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Using REXXOUT data sets IBM Health Checker for z/OS User's Guide SC23-6843-02 |
|
Both TSO environment (REXXTSO(YES)) and non-TSO (REXXTSO(NO)) environment
REXX checks can use REXXOUT data sets to diagnose REXX check problems.
The REXXOUT data set is provided when the check is in debug mode and
is intended to capture data used to debug the check. When a REXXOUT
data set is provided, System REXX writes data to the REXXOUT data
set every time:
From
SDSF, you can also place a REXX check in debug mode by over-typing
the DEBUG field to ON.REXX check exception, information, and report messages are written to the message buffer rather than the REXXOUT data set. The system will allocate the REXXOUT data set for you based on the naming conventions for your environment, if it is not already allocated when the REXX check runs. However, you must ensure that IBM® Health Checker for z/OS® address space has the authority to allocate the data set. If the system cannot exclusively allocate or use the REXXOUT data set, the REXX check will not run successfully. |
Copyright IBM Corporation 1990, 2014
|