Dumping RRS information

When the IBM® Support Center requests an RRS dump, they typically ask for the same data every time. To save time, create two IEADMCxx parmlib members.

Note: If your installation setup RRS with a job name other than 'RRS', replace that value in both the JOBNAME and DSPNAME parameters in the following examples:

To dump RRS: Create an IEADMCxx parmlib member with the requested RRS dump parameters as follows:
```
JOBNAME=(RRS),DSPNAME=('RRS'.*),
SDATA=(ALLNUC,LPA,LSQA,PSA,RGN,SQA,TRT,CSA,GRSQ,COUPLE)
```
When you need a dump of RRS, use the following command:
```
DUMP COMM=(title),PARMLIB=xx  
```
xx is the suffix of the IEADMCxx parmlib member that contains the RRS dump options.
To dump RRS and system logger: Create an IEADMCxx parmlib member with the requested RRS and system logger dump parameters as follows:
```
JOBNAME=(RRS,IXGLOGR),DSPNAME=('RRS'.*,’IXGLOGR’.*),
SDATA=(ALLNUC,LPA,LSQA,PSA,RGN,SQA,TRT,CSA,GRSQ,COUPLE)
```
Then, when you need a dump of RRS and system logger, use the following command:
```
DUMP COMM=(title),PARMLIB=xx  
```
xx is the suffix of the IEADMCxx parmlib member that contains the RRS and system logger dump options.

If exploiters are involved, you can include them in the JOBNAME list in your IEADMCxx parmlib members.