To invoke CEEXOPT and create the CELQROPT load module, follow these
steps:
- Copy member CELQRDOP from CEE.SCEESAMP into CEEWQROP in place
of the comment lines following the SYSIN DD statement.
- Change the parameters on the CEEXOPT macro statement to reflect
the values that you chose for this region-level load module.
- Code only the options that you want to change. Options that you
omit from CELQROPT remain the same as the system-level defaults (if
present) or the IBM-supplied defaults.
- Change DSNAME=YOURLIB in the SYSLMOD DD statement
to the name of the partitioned data set into which you want your CELQROPT
load module to be link-edited.
Note: If you have a CELQROPT module
in the specified data set, it will be replaced by the new version.
- Check the SYSLIB DD statement to ensure that the data set names
are correct.
CEEWQROP should run with a condition code of 0.