Perform the following steps to modify the JCL for CEEWLNUE:

1. Replace the comment lines following the ++ SRC statement in CEEWLNUE with your updated CEEBLNUE CSECT identifying your abnormal termination exit routine.

   _________________________________________________________

2. Change #GLOBALCSI to the data set name of your global CSI data set.

   _________________________________________________________

3. Change #TZONE to the name of your target zone.

   _________________________________________________________

4. Add necessary SMP/E PRE information for PTFs you have installed on your system which contain the same part.

   _________________________________________________________

When you are done, CEEWLNUE should run with a condition code of 0.