Perform the following steps to modify the JCL for CEEWCEXT:
- Replace the comment lines following the ++ SRC statement
in CEEWCEXT with your updated CEEEXTAN CSECT identifying your abnormal
termination exit routine.
_________________________________________________________
- Change #GLOBALCSI to the data set name of your global CSI data
set.
_________________________________________________________
- Change #TZONE to the name of your target zone.
_________________________________________________________
- Add necessary SMP/E PRE information for PTFs you have installed
on your system which contain the same part.
_________________________________________________________
When you are done, CEEWCEXT should run with a condition code of
0.