Data selection parameters limit the scope of the data
in the report. If no data selection parameter is selected, the default
is DETAIL.
- DETail
- Requests formatting all control blocks for the selected components.
Only significant fields in each control block are formatted. For the
Heap and Storage Management Reports, the DETAIL parameter will provide
a detailed heap segment report for each heap segment in the dump.
The detailed heap segment report includes information on the free
storage tree in the heap segments, and all allocated storage elements.
This report will also identify problems detected in the heap management
data structures. For more information about the Heap Reports, see Understanding the HEAP LEDATA output.
- EXCeption
- Requests validating all control blocks for the selected components.
Output is only produced naming the control block and its address for
the first control block in a chain that is invalid. Validation consists
of control block header verification at the very least. For the Summary,
CEEDUMP, C/C++ reports,
the EXCEPTION parameter has not been implemented. For these reports,
DETAIL output is always produced.