vmfbld ppf P696234K {HLASM|HLASMSFS} (status

VMFBLD2185R The following source product parameter files have been
            serviced.
VMFBLD2185R P696234K $PPF
VMFBLD2185R When source product parameter files are serviced, all
            product parameter files built from them must be recompiled
            using VMFPPF before VMFBLD can be run.
VMFBLD2185R Enter zero (0) to have the serviced source product
            parameter files built to your A-disk and exit VMFBLD so
            you can recompile your product parameter files with VMFPPF.
VMFBLD2185R Enter one (1) to continue only if you have already
            recompiled your product parameter files with VMFPPF.

Select 1 if you have previously compiled your product parameter files. In this case, go to Step 7: Rebuild serviced parts (objects).

When you select 0, then these steps recompile the product parameter files (PPF).

1. Indicate $PPF file needs to be compiled

   Command	Explanation
   0	Enter a 0 and continue with the following commands.

   The message

   VMFBLD2188I Building P696234K $PPF on 191 (A) from level $PFnnnnn

   is displayed.

2. Compile the product parameter file

   Command	Explanation
   vmfppf P696234K *	If you have your own PPF override, use your PPF name instead of P696234K.

3. Copy the product parameter file to software inventory disk

   Command	Explanation
   copyfile P696234K $PPF a = = d (olddate replace
   	Do not use your own PPF name in place of P696234K for this COPYFILE command.

   Options:

   olddate

   Uses the date and time on each input file as the date and time of the last update of each corresponding output file.

   replace

   Causes the output file to replace an existing file with the same file identifier.

4. Erase product parameter file from A disk

   Command	Explanation
   erase P696234K $PPF a	Do not use your own PPF name in place of P696234K for this ERASE command.

5. Update build status table

   Command	Explanation
   vmfbld ppf P696234K {HLASM|HLASMSFS} (status
   	VMFBLD updates the build status table.   Use HLASM if HLASM Toolkit Feature is installed on minidisk. Use HLASMSFS if HLASM Toolkit Feature is installed in SFS.
   1	When you receive the VMFBLD2185R prompt, enter a 1 to continue.

   Options:

   status

   Identifies build requirements.

6. Review the build message log

   Command	Explanation
   vmfview build	Command to review the build status messages and see which objects need to be built.