HLASM Toolkit Feature Installation and Customization Guide
GC26-8711-09
Receive new service
Note: If you are installing multiple service
tapes, you can receive all the service for this product before applying
and building it. For each service tape or electronic envelope you
want to receive, do the following:
If receiving the service from tape:
Command
Explanation
vmfrec ppf P696234K {HLASM|HLASMSFS}
Command to receive service from the service tape. All new service
is loaded to the alternate DELTA disk. Use HLASM if HLASM
Toolkit Feature is installed on minidisk. Use HLASMSFS if
HLASM Toolkit Feature is installed in SFS.
If receiving the service from the PTF envelope file:
This command receives service from your service envelope. All
new service is loaded to the DELTA disk. envfilename is the
filename of the service (PTF) envelope (SERVLINK) file. Use HLASM if
HLASM Toolkit Feature is installed on minidisk. Use HLASMSFS if
HLASM Toolkit Feature is installed in SFS.
Review receive message log
Command
Explanation
vmfview receive
Command to review the receive message log ($VMFREC $MSGLOG).
Correct any problems before you go on. For
information about specific error messages, refer to z/VM: Other Components Messages and Codes.