Step 7. Rebuild serviced parts (objects)

Rebuild serviced parts

Command

Explanation

vmfbld ppf P696234J {HLASM|HLASMSFS} (serviced

Command to rebuild serviced parts. If you receive message VMFSBR2000I then you need to rebuild the segment holding High Level Assembler code.

Note: If your Software Inventory disk (51D) is not owned by the MAINT user ID then make sure the VMSESE PROFILE reflects the correct owning user ID. Use HLASM if High Level Assembler is installed on minidisk. Use HLASMSFS if High Level Assembler is installed in SFS.

Options:

serviced: Identifies build requirements and builds those objects flagged as serviced in the service-level build status table.

Review build message log

Command	Explanation
`vmfview build`	Command to review the build message log ($VMFBLD $MSGLOG). Correct any problems before going on. For information about specific error messages, refer to z/VM: Other Components Messages and Codes.