HLASM Installation and Customization Guide
SC26-3494-05
Receive New Service
Note: If you are installing multiple service tapes, you can
receive all the service for this product before applying
and building it. For each service tape or electronic envelope
you want to receive, do the following:
If receiving the service from tape:
Command
Explanation
vmfrec ppf P696234J {HLASM|HLASMSFS}
Command to receive service from the service tape.
All new service is loaded to the alternate DELTA disk.
Use HLASM if High Level Assembler is installed on minidisk.
Use HLASMSFS if High Level Assembler is installed in SFS.
If receiving the service from the PTF envelope file:
This command receives service from your service envelope. All new
service is loaded to the DELTA disk.
envfilename is the filename of the service (PTF) envelope
(SERVLINK) file.
Use HLASM if High Level Assembler is installed on minidisk.
Use HLASMSFS if High Level Assembler is installed in SFS.
Review the receive message log.
Command
Explanation
vmfview receive
Command to review the receive message log ($VMFREC $MSGLOG).
Correct any problems before you go on.
For information about specific error messages, refer to
z/VM: Other Components Messages and Codes.